Assess & quote
Site visit, plan review and Dial Before You Dig. One clear quote covering dig, cartage and cleanup.
Potts Point is a grand art-deco apartment ridge on sandstone above the harbour, basement and lift-pit work cut into rock. The regular jobs here are basement digs, shoring and underpinning. Services located first, sites left level and clean.
Get a free quoteNo obligation, free site quote.
Got it, thanks. We'll be in touch to arrange your site assessment and clear quote.
From a knock-down rebuild to a new estate pad, each service has its own page with the detail.
Potts Point sits about 3 kilometres east of the city. You'll recognise it by Macleay Street, Elizabeth Bay House nearby and Fitzroy Gardens. It's ringed by Kings Cross, Elizabeth Bay, Woolloomooloo and Rushcutters Bay. What's changing: basement garages and lift pits cut into rock beneath apartments, and heritage refurbishments.
Around Potts Point, near Macleay Street, you're mostly on art-deco and Victorian apartments and terraces, with dense heritage character. Near Macleay Street, the heritage streets carry conditions near the listed houses. On a Potts Point block that usually means basement digs, shoring and underpinning.
On the harbour ridge, Potts Point sits on Hawkesbury sandstone with rock close to the surface, out by Macleay Street. On the Potts Point blocks toward Elizabeth Bay House nearby the rock is shallow, so pools, piers and basements are sawn clean and broken rather than dug. Around Elizabeth Bay, the sandstone is sawn at the boundaries and carted out as rock.
Potts Point is City of Sydney ground; near Macleay Street, heritage controls apply and we dig to the approved plans. The Potts Point crew comes in off Victoria Street or Challis Avenue, where the slope is worked in benches with retaining.
Every job follows the same sequence, whether it's a single trench or a full site cut.
A trench can be a day, a basement can be weeks. Dates come with the quote, not after.
Potts Point and the streets around it, from the older estates to the new blocks.
From the older streets to the newer blocks, Potts Point and the suburbs around it. If you're anywhere in the Potts Point area, we can get to you.
See the whole city and South Sydney area →It depends on the volume of material, the ground (hawkesbury sandstone with rock close to the surface on the harbour ridge), access for the machine and how far spoil has to be carted. Every job gets a written quote after a site look, with the dig, cartage and cleanup spelled out, so you know what’s included before anything starts.
Usually, if the excavation is part of a build. Cut and fill beyond set limits, work near boundaries and anything on a lot with a flood, bushfire or heritage overlay needs approval as part of the DA or CDC. We work to the approved plans; check with your certifier before the dig is booked.
A trench, pool dig or single pad is a day or two; a knock-down site cut or a basement runs longer and depends on volume, ground and weather. Dates come with the quote, not after.
Yes. Hawkesbury sandstone with rock close to the surface on the harbour ridge. The inner city sits on sandstone, usually right under the terrace floors. It’s sawn against the party walls and broken out in stages, and it’s in the quote from the site look.
Yes. The party walls are supported to the engineer’s underpinning design, the ground is dug in stages through the front or the lane, rock is sawn at the walls so the neighbours’ footings stay put, and spoil goes out by conveyor. Heritage conditions apply on most of these streets.
Yes. South Sydney basements are shored digs through fill and sand with the water table close, dewatered to the council’s controls, spoil classified and carted to the right facility, and trucks scheduled around the traffic so the street stays open.
Through the front room on boards with the floor protected, or over the roof by crane. Spoil comes out the same way in bins. Slower than anywhere with a side gate and priced for it, but it’s how inner-city courtyards get dug.
Yes. A sloping block is benched into levels with retaining planned in, and the machine is chosen for the grade and the ground. On sandstone slopes the benches are cut into rock. The site look decides the approach.
Tell us about the job. We'll look at the site before quoting, so you know what's included before anything starts.
Request received. We'll be in touch to arrange your site assessment and clear quote.