Assess & quote
Site visit, plan review and Dial Before You Dig. One clear quote covering dig, cartage and cleanup.
Elizabeth Bay is a harbour-slope apartment enclave on sandstone, tight basement and retaining work over rock with harbour views. The regular jobs here are basement digs, shoring and underpinning. Services located first, sites left level and clean.
Get a free quoteNo obligation, free site quote.
Got it, thanks. We'll be in touch to arrange your site assessment and clear quote.
From a knock-down rebuild to a new estate pad, each service has its own page with the detail.
Elizabeth Bay sits about 4 kilometres east of the city. It's anchored by Elizabeth Bay House, Beare Park and Sydney Harbour. It's ringed by Potts Point, Kings Cross, Rushcutters Bay and Darling Point. What's changing: basement garages and lift pits cut into rock beneath apartments, and heritage refurbishments.
In Elizabeth Bay, near Elizabeth Bay House, it's mostly art-deco and Victorian apartments and terraces, with dense heritage character. Near Elizabeth Bay House, the heritage streets carry conditions near the listed houses. On a Elizabeth Bay block that usually means basement digs, shoring and underpinning.
Elizabeth Bay sits on Hawkesbury sandstone with rock close to the surface on the harbour ridge, out toward Elizabeth Bay House. Around Beare Park a Elizabeth Bay dig hits sandstone in the first metre, sawn at the edges so the neighbour's ground stays put and broken in the middle. Around Kings Cross, the sandstone is sawn at the boundaries and carted out as rock.
Elizabeth Bay is in City of Sydney, and the Elizabeth Bay House blocks carry heritage controls, dug to the approved plans. Machines come in to Elizabeth Bay off Onslow Avenue or Elizabeth Bay Road, and the grade means benching and retaining.
Every job follows the same sequence, whether it's a single trench or a full site cut.
A trench can be a day, a basement can be weeks. Dates come with the quote, not after.
Elizabeth Bay and the streets around it, from the older estates to the new blocks.
From the older streets to the newer blocks, Elizabeth Bay and the suburbs around it. If you're anywhere in the Elizabeth Bay area, we can get to you.
See the whole city and South Sydney area →It depends on the volume of material, the ground (hawkesbury sandstone with rock close to the surface on the harbour ridge), access for the machine and how far spoil has to be carted. Every job gets a written quote after a site look, with the dig, cartage and cleanup spelled out, so you know what’s included before anything starts.
Usually, if the excavation is part of a build. Cut and fill beyond set limits, work near boundaries and anything on a lot with a flood, bushfire or heritage overlay needs approval as part of the DA or CDC. We work to the approved plans; check with your certifier before the dig is booked.
A trench, pool dig or single pad is a day or two; a knock-down site cut or a basement runs longer and depends on volume, ground and weather. Dates come with the quote, not after.
Yes. Hawkesbury sandstone with rock close to the surface on the harbour ridge. The inner city sits on sandstone, usually right under the terrace floors. It’s sawn against the party walls and broken out in stages, and it’s in the quote from the site look.
Yes. The party walls are supported to the engineer’s underpinning design, the ground is dug in stages through the front or the lane, rock is sawn at the walls so the neighbours’ footings stay put, and spoil goes out by conveyor. Heritage conditions apply on most of these streets.
Yes. South Sydney basements are shored digs through fill and sand with the water table close, dewatered to the council’s controls, spoil classified and carted to the right facility, and trucks scheduled around the traffic so the street stays open.
Through the front room on boards with the floor protected, or over the roof by crane. Spoil comes out the same way in bins. Slower than anywhere with a side gate and priced for it, but it’s how inner-city courtyards get dug.
Yes. A sloping block is benched into levels with retaining planned in, and the machine is chosen for the grade and the ground. On sandstone slopes the benches are cut into rock. The site look decides the approach.
Tell us about the job. We'll look at the site before quoting, so you know what's included before anything starts.
Request received. We'll be in touch to arrange your site assessment and clear quote.